10-17-2023 08:33 AM - edited 10-17-2023 08:34 AM
Hello, I would like to create a VPN Tunnel between HQ1 and HQ2 for Valn11 (Network 192.168.27.128/26 and 192.168.28.128/26).
I checked the settings a couple of times but it seems that the VPN Tunnel did not work.
The setting have done when checking with show crypt map command and show run.
However, When I ping H3 (192.168.28.130) by H1 (192.168.27.130) and checking with show crypt ipsec sa command, there are no pocket are transferred from VPN Tunnel.
Can anyone tell me where I made a mistake please.
10-17-2023 08:37 AM
share the config here, I can not open zip file
10-18-2023 01:50 PM
it works one way only; from H3 to H1 or from right side to left, but not other way; You have NAT on one side, left side but not on right side, another company; normally ISP will not route any private range subnet like yours 192.168.x.x, so you would need NAT/PAT on both sides. Anyway, I am not sure if NAT/Pat is set up correctly.
Since this is PT simulator, be care full adding too much to this lab; not sure if u can run NAT/PAT with IPsec.
Regards, ML
**Please Rate All Helpful Responses **
10-19-2023 02:48 AM
Thank you!! I tried to NAT/PAT on right side and it's work!!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide