Web Security

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 

Forum Posts

Our Ironport S160 seems to be allowing cloud based services such as Dropbox and Amazon, but for some reason SugarSync fails to work through the WSA.  I freely admit that I'm not very experienced with this product (I didn't set it up in the first plac...

I have an S160 WSA and want to enable the Web service for http and https. I am using transparent mode with WCCP. This is part of the router configuration:ACL:access-list 110 permit tcp 192.168.80.0 0.0.7.255 any eq 80 access-list 120 permit tcp 192.1...

Hi,I recently set up a new Ironport identity group and access policy to assign to the new group.I can't seem to get HTTPS web sites working with this goup, it seems to just get dropped by the proxy.HTTPS is working fine for the exisiting access polic...

Berz123 by Level 1
  • 2585 Views
  • 2 replies
  • 0 Helpful votes

Hello,I have a IronPort S170 and I am trying to activate windows online for workstations that use ironport.On the workstation i get the 0x80072f8f error.I have tried activating windows without going through Ironport and works fine.Is there a way I ca...

With Juan RamosWelcome to the Cisco Support Community Ask the Expert conversation. This is an opportunity to learn how to configure, troubleshoot, and optimize the Cisco Web Security Appliance (WSA) with Cisco technical support expert Juan Daniel Ram...

We currently have and inline content filter we are upgrading to a Cisco WSA.  I am in the final stages and I have a couple of questions in regards to the deployment of the device.  I would like to use WCCP to do this and I have a few questions.Curren...

Hi all,I just setup an ironport S160 appliance on my network. The applaince shows to be up but it does not seem to be capturing users activities. the following are the configuration details:Mode: Transparentdata interface: P1 onlymngt int: management...

IronPort and Cisco ACS5.1 AAA integrationHello,could  someone points me to some docs explaining how to integrate IronPort  appliance with Cisco ACS server 5.1 for admin access , operater access and viewer access and authentication  logs (if possible)...

alex-bank by Level 1
  • 2303 Views
  • 6 replies
  • 0 Helpful votes

In the IronPort web security appliance documentation, it indicates that the L4 traffic monitor ports (T1 and/or T2) should be connected to either a network tap or switch span.I'm a little confused as to how this is supposed to be set up.Does it mean ...

Resolved! Future - WSA

Gents.We are currently evaluating a new proxy/filter solution and as we are very happy with the Ironport Email Security appliance we are considering the WSA S370. I have been told focus from Cisco now is shifting to their cloud based service (ScanSaf...

Top Solution Authors