Web Security

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 

Forum Posts

We recently migrated to S300v.  Since that our emailed daily reports don’t work.  I can’t figure out why since they came over from the config from a S170 where the reports worked fine.   In the reports section I even preview them and it looks great. ...

We were doing some troubleshooting with Cisco and to see which WSA's had current traffic through them they told us about the rate command. I've never seen this before and was curious what hits/blocks/misses mean? I'm assuming blocks is blocked URL's....

Hello   I have a cisco asa 5505, IOS 9.1.6   I have a question that when I try to type below command, it can not configure. LTHCN031(config-pmap-c)#   inspect dns preset_dns_map ERROR: DNS policy-map preset_dns_map not configured   would someone can ...

gdy1039 by Level 1
  • 4792 Views
  • 3 replies
  • 0 Helpful votes

Probably a simple answer to this question. If a site, say Google.com has both http and https, is there anything special I need to do to allow both sites?  Is all I need for this is  google.com and .google.com?   Or do I need a regex of http?://.*goog...

Hi there,   For a customer of ours we're currently running ASyncOS version 10.1.1 on a physical S190 web security appliance. We want to update the appliance to ASyncOS version 10.5.1. We're running the appliance as a single unit in a datacenter and w...

Tom95 by Level 1
  • 3094 Views
  • 5 replies
  • 0 Helpful votes

Hi ,   I have two LAN IP (LAN and WIFI Traffic) from cisco ASA firewall and it is routed to cisco router ,cisco router is redirect back to Web proxy and web proxy routed back to router as single IP for both LAN and WIFI.   Here i want to do load bala...

Hi All,   So we have had Ironport (now Cisco WSA) for a good 5 years now, all virtual running 9.1 and all working fine except:   we have around 5,000 ipads on the infrastructure, they are all on a specific wireless flex connect vlan, when they hit th...

We are having problems trying to identify why the WSA is blocking Slack calls.  We are seeing the following error...   SyslogAccess: Info: 1510782070.590 0 10.129.X.X TCP_DENIED/407 0 CONNECT tunnel://slack-calls-0f839364977b8qwdsc8.slack-core.com:44...

flyerhawk by Level 1
  • 1426 Views
  • 1 replies
  • 0 Helpful votes
Top Solution Authors