cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1256
Views
0
Helpful
6
Replies

Connect via P2 Interface to WSA S160 for initial set-up

FLOYD SALAZAR
Enthusiast
Enthusiast

Currently have deployed WSA with the following interfaces:

1/ Management : 1.1.2.2/24

2/ P1 : 10.10.20.14/24 (inside DMZ interface for secure network)

3/ P2:  8.8.8.136/28 (Public DMZ interface)

Issue:

I can not reach Management interface on segment at this time to run set-up wizard for configuring the WSA.

I can reach and talk to P2 interface via ASA 5540 which controls all inbound traffic to WSA.

How can I remotely reach WSA via P2 to run setup wizard via GUI for WsA set-up?

I know I must use http://IP_ADS:8080/8443 but how can I get there via public IP Address or proxy.

Note: I have a proxy 5.5.5.5 which I have built acl on 5540 to allow tcp 8080/8443 to 8.8.8.136.

6 Replies 6

Tery Le Febvere
Cisco Employee
Cisco Employee