Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Currently have deployed WSA with the following interfaces:1/ Management : 1.1.2.2/24 2/ P1 : 10.10.20.14/24 (inside DMZ interface for secure network)3/ P2: 8.8.8.136/28 (Public DMZ interface)Issue:I can not reach Management interface on segment at t...
Hi,I have Hub -Spoke design that is active for private network traffic.How can I add a VRF and force the Internet traffic into the tunnel and is there a standard configuration for this?I am using EIGRP to propagate traffic from the Hub and I want to...
Question:In commissioning a Hub and Spoke Architecture in a DMVPN design.My question for each spoke router that is looking to authenticate into the network with CA nodes does each router create its own RSA key.Here is the configuration for each spoke...
How does one allow /31 mask for an management interface on an ASA5540 using version 8.3(1)?I need to configure a 192.168.x.y /31 on the management 0/0 interface of a ASA5540 and it is providing me with the following error:ERROR: /31 mask is not allow...
currently I have deployed ESA C160 and WSA S160 devices in a network but I cannot remotely connect to the devices.I have installed Cisco 2811 Terminal server with octal cable connections and cannot seem to get terminal access.As well I have connected...
Good Evening Tery,Here is a thought to be able to utilize the setup wizard for the S160 WSA on the management interface.If I physically move the Management interface to the same subnet of P2 interface with a different IP which is accessible via firew...
Good Day Tery,Yes I have console or serial port access to the device at this time.My concern is if you cannot run the set-up wizard via the management interface what effective way can one build the base configuration of the WSA without using the set-...
Good Evening Tery,The problem is that 1.1.2.2 is not accessible, which means the Management segment is not accessible via http or https at all.It was provisioned given an IP Address which cannot be accessed currently.So is there another way to use th...
Hi,No problem, I am new to work with the C160 device as well so I am learning what is best.I asked a local technician to connect via his laptop but I am assume he did not have a null-modem adapter to use.I guess I should simply get some DB-9 null-mod...
