Gateway for P1 and P2

[kostasthedelegate]

Hello, 

I would like to set different gateway for M1, P1 and P2 in WSA 

Is that possible?

How it is configured?

Thanks and regards, 

Konstantinos

[Rob Ingram]

Hi @kostasthedelegate 

Yes this is possible. Each interface would be physically connected to a different VLAN and you specify the relevant default gateway. The WebUI location is network > interfaces tab.

HTH

[Ken Stieers]

You can set default gateway for each interface as well any static routes you need on the Network/Routes page.

[kostasthedelegate]

Ok

So I cannot have a separate gateway for P1 and a separate for P2?

[kostasthedelegate]

The thing is that I have P1 and P2 with different gateways, but I cannot seem to be able to set them. 

[hcombee]

For data traffic there is one routing table, but you can set for instance a route for RFC1918 adresses to the gateway of P1 and a default route to the gateway of P1.