iccm_configuration_publish

[gilberto.lopes]

Hello,

I am testing two WSVA and a SMA to manage both boxes.

When trying to publish via the settings between the boxes, the Failure error message: Protocol parse error: The command "_ iccm_configuration_publish" does not takeany arguments.

I've checked the settings, I did research and found nothing so far to address this problem.

Thank you all so much.

[Handy Putra · Accepted solution]

Hello,

Please make sure both SMA and virtual WSAs AsyncOS are compatible to each other else that error will occurs.

Typical scenario is that the SMA is running version 9.6.x while the WSA is running version 9.2.0 (which not supported yet by SMA).

You can also check the compatibility matrix from below link:

http://www.cisco.com/c/dam/en/us/td/docs/security/security_management/sma/sma_all/SMA-ESA-WSA_Compatibility.pdf

Hope this helps.

[gilberto.lopes]

Incompatible version both  SMA 10.0.0.088 and WSVA 9.2

Thank You!