12-10-2010 06:40 AM
I want know if this IronPort S160 make a cluster Master-Slave with WCCP, or HA?
Anyone know about this?
Best Regards.
12-13-2010 09:31 PM
Hello Sergio,
There is no concept of Master and Slave on WSA.
WCCP does the automatic load balancing, on the configured WSA group.
You can also specify which traffic goes to which wccp device.
Some information on WCCP here
I hope that helps you.
Regards,
Eric
11-03-2017 01:17 PM
Good day,
I would like to know if there is any document showing the step by step to perform load balancing and HA configuration between a WSA and vWSA through WCCP on a Cisco ASA Firewall.
On the other hand I have the doubt when this type of configuration is done as it is done so that when making some configuration change replicate in the two WSA (physical WSA and virtual vWSA).
Thank you in advance for the collaboration and help you give me.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide