Transfer SMA to virtual And CM mismatch

[kostasthedelegate]

Hello, 

I have a physical SMA 11.0.1-161 and WSAs 11.7.1-020

I have set a new virtual SMA 13.8.1-052 and I would like to transfer the config.

I set up a temp SMA same version with physical in order to transfer the config and perform the updates. 

I successfully loaded the config. 

When I upgraded to the latest version the configuration master(10.5) was gone.., because it only supported newer CM. 

What should I do to transfer the config to the latest version;

Thanks and regards, 

Konstantinos

[balaji.bandi]

You need to re-intialise the config, 13.X will not able to read the old 11.X config, So WSA need to 12.X

[kostasthedelegate]

Ok 

So I will have to connect the WSA to re-initialise?

Or should I upgrade first to a version previous that 13.8?

[kostasthedelegate]

Hello, 

I have tried different versions to upgrade ( 13.8.1-052 which is the final I want to go and 13.6.2-058) and when I upgrade the CM is gone 

In the current version 11.0.1-161, I have also CM 11, but I cannot initialize it from the CM 10.5 that I have

I need your help to understand how will I transfer the CM to the upgraded version of SMA.

Regards, 

Konstantinos