cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
6519
Views
10
Helpful
6
Replies

WSA clustering / configuration sync

Marcel Maeder
Enthusiast
Enthusiast

Hello

Is it possible to build a cluster with two WebSecurity Appliances? Or at least synchronize the configuration?

Regards Marcel

2 Accepted Solutions

Accepted Solutions

Hello:

    Officially this is not supported out of the box, you need the Ironport M appliance to centralize and distributed the same config to the other WSA.
    Since not always everything it's an absolute truth, there is a way using a linux box in the middle acting as an Ironport M that is able to register these changes and populate them to the rest of WSA, but this solution was built in house and work pretty well. The problem is that it's not supported by Cisco.

Regards

Francisco Rodriguez P.

View solution in original post

WSA cluster is only for data traffic. You still need SMA for centralized policy management.

View solution in original post

6 Replies 6

Hello:

    Officially this is not supported out of the box, you need the Ironport M appliance to centralize and distributed the same config to the other WSA.
    Since not always everything it's an absolute truth, there is a way using a linux box in the middle acting as an Ironport M that is able to register these changes and populate them to the rest of WSA, but this solution was built in house and work pretty well. The problem is that it's not supported by Cisco.

Regards

Francisco Rodriguez P.