Control Video Projector from Webex Codec

[jtwormley]

I am looking for information on how to control a video projector from a Webex Codec. I know there is third party hardware available. I would like to go directly from the the codec to the project via either RS232 or network commands. 

[Alexander Stevenson]

Hi @jtwormley,

If you don't get a good answer here, you can check out the support page for Webex for Devs --> https://developer.webex.com/support

There are a couple options there for you to get assistance which is specific to Webex development. The group chat stays busy but you must be logged into the page linked above in order to join it.