To enable all ports, enter these commands in configuration mode:
port adminmode all enable
network webmode enable
network secureweb enable
The port adminmode command enables Web Graphical User Interface (GUI) access on all of the ports on the controller. The network mode enable command also allows HTTP access (in addition to HTTPS, if configured).
To enable secure web mode (HTTP), issue the network secureweb enable command. After every command is issued, reboot the controller for the changes to take effect.
Cannot console or telnet or GUI into a device
WLAN adapters (wireless card) / ACU (Aironet Client Utility)
We're having a heck of a time getting our Carrier Infinity Thermostats (SYSTXCCITC01-B) connected to our Cisco wireless network. The network is rock sold (running vWLC version 8.5.151 and the access points are either 2802i's or 3802i's). ...
Hi,I am trying to run the WLAN poller tool against WLC 5520. User authentication is via ACS. I am using AAA credentials for the poller tool to authenticate for WLC and AP. But when I run the tool, i see error message that the WLC failed to respond.Is ther...
Hi all,It is my guess that one can the Service Port IP address.. when ever, without causing/needing a reboot.. Yes or No?I have a standalone LAB unit that I changed the SP ip on and the GUI (on mgnt ip) dropped out.. unit still pinged..W...
We have a Cisco 3504 WLC anchor controller that provides anchoring to several remote foreign controllers for certain WLAN's. This anchor is a single point of failure, and we are looking at options for providing redundancy in the event of a controlle...
Hello everybody, I have some questions about Band Select, MAC address randomization and Probe Request/Response. Please, feel free to contribute and add your own questions to this discussion. 1) How is Band Select feature impacted by MAC add...