10-28-2013 01:22 AM - edited 11-18-2020 03:04 AM
Final Image 7.4.121.0 is now posted to CCO, thanks for all your feedback
CSCul58609 | Dataplane crash nbar timer wheel corrupt and Heartbeat miss |
CSCul77973 | Upgrade from 7.6 to 8.0 with existing AVC prof client traffic fails |
CSCul94742 | controller crash with memory corruption |
CSCuj12935 | wism2 hung on 7.4.110.0 with memory allocation issues at load. |
CSCul65002 | WLC frequently crashes silently @ewaFormSubmit_exp_list with 7.4.110.0 |
CSCul68057 | CF driver change for 5508/WiSM2/2504 |
CSCuh71233 | Flex Stress Test: SYS-2-INTSCHED - all interrupts disabled |
CSCul50441 | AP: Crash: Check HEAPS; %SYS-6-BLKINFO: Corrupted redzone blk 12CE8C4 |
CSCul81023 | Controller crash with spamReceiveTask in 7.4.111.13 on HREAP setup |
CSCui11302 | write the image directly into flash |
CSCui67039 | Unable to downgrade WLC from 7.6.1.52 to 7.5 CCO build when in HA |
CSCuj88982 | multicast fails sometimes, WLC ignores IGMP, if AVC is enabled on wism2 |
CSCuj99846 | WLC HA: Incorrect Mesh AP count after HA failover |
CSCul20597 | Local EAP stops working after FTP config upload |
CSCul55930 | Saber 8500 Reaperwatcher crash |
CSCud10611 | Client exclusion notifications should be sent only to APs in the group |
CSCul25937 | Trap Scale improvements for client Association |
CSCul63384 | WLC system crash : Bonjour_Process_Task |
CSCuj88982 | multicast fails sometimes, WLC ignores IGMP, if AVC is enabled on wism2 |
CSCuj99846 | WLC HA: Incorrect Mesh AP count after HA failover |
CSCul20597 | Local EAP stops working after FTP config upload |
CSCul55930 | Saber 8500 Reaperwatcher crash |
CSCud10611 | Client exclusion notifications should be sent only to APs in the group |
CSCul25937 | Trap Scale improvements for client Association |
CSCuj99846 | WLC HA: Incorrect Mesh AP count after HA failover |
CSCuj64462 | AP radio flapping w/ CleanAir down, could not connect to spectrum FW |
CSCue20209 | cleanair unable to report interference. |
CSCue88466 | SC2 radio firmware download fails CRC check cmd for certain image sizes |
CSCui84582 | Bcast queue is full when IGMP is disabled -"RX Multicast Queue Full" |
CSCul30051 | Clients failing auth (psk/dot1x) due to uncreated dot1x interface for AP |
CSCud69687 | Talwar:AP count is not reflected correct in "show ap summary" |
CSCul22530 | Reaper Crash on Bonjour_Msg_Task |
CSCui36121 | AP crash in dot11_driver_timer_expiry() after AES-CCMP TSC replays |
CSCui82573 | Double AID allocation in OKC Fast Roaming in FlexConnect |
CSCud09069 | unable to add ip mask with 0.0.0.0 |
CSCue49527 | WLC should delete the session ID from PMK cache when client is removed |
CSCui50515 | dhcp proxy selecting wrong ip after using cached AAA override values |
CSCul16913 | massive AP radio's tx power changed when the system is overheated |
CSCul26859 | Not able to disable radius auth and acct for wlan thru GUI |
CSCul27717 | APs disassociate in large scale setup when debug commands are executed |
CSCui84582 | Bcast queue is full when IGMP is disabled -"RX Multicast Queue Full" |
CSCui66891 | Marvell-based radio goes down due to stuck multicast packets in driver |
CSCuj36260 | cannot disable mDNS snooping on WLAN with local switching after upgrade |
CSCuj87123 | Controller getting crashed while install license |
CSCuf16416 | .11h Client gets deauthenticated in non-dfs channel after dfs simulation |
CSCue59791 | Poor VPN Performance on 3600 APs |
CSCuj12898 | WiSM2 crashing on Bonjour_Msg_Task |
CSCuh25556 | Fix Aggr Sched AVL tree corruption crashes w/ design change to doubly-LL |
CSCui26351 | default route to BVI1 may stay on routing table |
CSCui43621 | 1552E flexconnect gig fiber port does not pass dhcp to wireless client |
CSCue25685 | Wi-Fi direct doesn't authenticate with 8500 |
CSCui25170 | APs can't join new WLC; mgmt int unreachable (BUFFER_POOL_LOW_DETECTED) |
CSCui55610 | Wrong status code returned for invalid FT IE MIC |
CSCui58670 | WLC sends M5 key with protected flag = 0 for a 802.11r SSID after a roam |
CSCuj21417 | AID leak causing Stale Client entries on WLC |
CSCuj25911 | wlc 7.4.110.0 RRM que full |
CSCuj28718 | WISM-2 in 7.4.110.0 code is crashing with "osapiReaper" task suspended. |
CSCud41334 | MAP Ethernet bridged client does not work |
CSCuj46010 | DTLS Conns getting dropped regularly causing APs to drop off from WLC |
CSCuj17884 | memory leak on HA AP SSO |
CSCuj18674 | captive portal/wispr support for apple ios7 |
CSCuc65606 | WLC crashes in spamreceive on 7.0.235.3 |
CSCud26706 | HA: Peer service port routes not shown after Switchover on 8510 |
CSCue34115 | 1552C Cable Modem AP's Gig Ethernet Link goes down. |
CSCug53945 | disabled radio is enabled after AP reload when AP group uses RF profile |
CSCug97769 | Device behind MAP unreachable after high AP uptime. Rebooting AP fixes |
CSCuh08009 | WPA2-PSK mac-filter assign interface wrong after client roaming back |
CSCui05324 | 1242 AP Radio Stops Transmitting - Transmit Queues Are Full |
CSCui20773 | Bcast queue is full -"RX Multicast Queue Full" |
CSCui25877 | Radio Reset: (ap1600) due to 'AMPDU attempt without BA setup from host' |
CSCui41685 | Add Show command support in CLI for Reap Payload |
CSCui59553 | Provide command to disable/customize dead GW detection for HA |
CSCui60915 | Mesh APs causing mac flapping and loop on the switch |
Great to see that we can get access to early release code for testing.
Hi George
Thanks for your comment!
Happy to see this helps, please let us know how the testing goes
regards
Javier,
I would really like to see the configuration documents released in EPUB format. Is there any chance of that happening in the future ?
Hi George
Doc team confirms that config documents and command reference are already in epub format:
Config guide: http://www.cisco.com/en/US/docs/wireless/controller/7.5/config_guide/b_cg75.epub
Command reference: http://www.cisco.com/en/US/docs/wireless/controller/7.5/command/reference/cr75.epub
Other tech docs will be published on epub format after December platform upgrade
regards
Hi Javier,
Will this release of code support the 3602I-Z AP? I am in a tricky situation where I cannot power on the 5GHz radio due to 7.4.110 code not supporting this AP. 7.5 does, however I have to downgrade to PRIME 1.4x which is not favourable.
Any information would be greatly appreciated.
hi
no sorry, for the moment, Z domain was added only on 7.5 and higher. if this is a mayor blocking point, please reach out to your account team, with the business impact/reasons so they can contact us an re-evaluate this if needed.
regards
Javier,
Will this code support the 1530 series APs
Regards
Hi Barry
No, 1530 support is introduced on 7.6, we normally don't add features/new HW to manteniance releases.
regards
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: