Important Information on Debug Commands
Here are some important pointers in order to capture the debugs.
- Please make sure that the following commands are configured on the router:
service timestamps debug datetime msec
service timestamps log datetime msc
service sequence-numbers
terminal exec prompt timestamp (from exec prompt)
Refer to the following link for more details about collecting debugs:
http://www.cisco.com/warp/public/793/access_dial/debug.html
- terminal no monitor ---- use “termimal monitor” to display debug command output and system error messages to a telnet session.
- no logging console------use “ logging console “ to display debug command output and system error messages to the console by severity level
- logging buffered----------- to specify the logging buffer as a destination for system logging (syslog) messages
- debug ip packet