Introduction
How to configure to hide the SSID from the GUI on the Cisco IOS-based access point
Resolution
In order to hide the service set identifier (SSID), the access point ideally does not broadcast the SSID. Complete these steps in order to stop the broadcast of the SSID:
- Choose Security > SSID Manager.
- At the bottom of the page, find the Guest Mode/Infrastructure SSID Settings.
- Remove the SSID from the Guest Mode in order to stop the broadcast of the SSID.

Note:
Some wireless cards do not work properly if the SSID is not broadcasted, since the Institute of Electrical and Electronics Engineers (IEEE) and WI-FI standards state that the SSID should be broadcast.
Problem Type
Configure / Configuration issues
Release notes / product overview / data sheet / FAQ
Products
Access point
Reference
Configuring SSIDs
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points, Cisco IOS Release 12.3(8)JA