Introduction
How to make minor changes to the Access Point when it crashes and reloads
Core Issue
The Access Point (AP) crashes and reloads during a hostname change running firmware version 12.2(15)XR2.
Resolution
To address this issue, refer to these Cisco bug IDs:
AP 1200 reboots or resets when running with version 12.2.15XR1. The reboots are not predictable in any manner of rebooting. The AP reboot requires two to four hours. The radios that run in the unit are the 802.11a and the 802.11g.
In the scenario of Cisco bug ID CSCee49659, if a user authenticates at the same time the Command Line Interface (CLI) is used to change the hostname, a reboot can occurred.
There is not enough information to determine why or when this occurs. There are no bugs reported where changing the hostname causes a crash.
CSCef50960 Details
AP1200 reboots/reset w
AP1200 will reboot or reset when running with the 12.2.15XR1 release. The reboots are not predictable or in any manner of rebooting. The AP are rebooting between 2 to 4 hours time. The radios that are running in the unit are the 802.11a and the 802.11g
Problem Type
Continuous reboot
Products
AP 340, 350
Reference
CSCef50960
CSCee49659
