Is it possible to apply VLAN on the link between Cisco Aironet Access Point (AP) and the Workgroup Bridge (WGB)

[TCC_2]

Resolution

A Cisco WGB device does not support multiple VLANs in it.  A 1100 AP, however, that acts in WBG mode can support multiple VLANs in it but with these restrictions:

• The VLANs must be assigned on both the root AP and WGB sides. On WGB use the command workgroup-bridge client-vlan to configure the VLANs.  On WGB make sure you map each VLAN to an SSID same as the Root AP.
  
  
• The WGB must be connected to a dot1Q-capable switch.
  
  
• The WGB associates as an infrastructure device. The Infrastructure SSID must be mapped to the native VLAN on root and the WGB.

Here are some of relevant URLs

• Cisco Aironet Workgroup Bridge FAQ
  
  
• Access Point as a Workgroup Bridge Configuration Example

Problem Type

Release notes / product  overview / data sheet / FAQ

Technical product specification / features

Products

Access point

Workgroup bridges

SW Features

VLANs