cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
809
Views
0
Helpful
0
Comments
TCC_2
Advocate
Advocate

Resolution

The Ethernet port (fec0) on your Access Point (AP), bridge, or base station may repeatedly start and stop, generating the following log messages:

Stopped driver for port "fec0"

Started driver for port "fec0"

If this happens continuously, proceed with the troubleshooting steps below. Check the results after each step.

  • Reboot or power cycle the unit.
  • Reset the unit to its factory default configuration and reconfigure.
  • Load the latest available firmware by referring to the Wireless LAN Cisco Downloads.

If these steps fail to resolve the problem, it is recommended that you contact the Cisco Technical Assistance Center (TAC) for further assistance.

Problem Type

Error message

Products

AP 340, 350

AP 1200

BR 340

BR 350

Base Station

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Quick Links