Core Issue
This error is typically caused by a failure at some level in the communication between the AP and the authentication server.
Resolution
Verify that you can ping from the Access Point (AP) to the server. For more information, refer to the Performing Pings and Link Tests section of Cisco Aironet 1200 Series Network Management.
Check the network to make sure that traffic between the two devices is not blocked by any intervening firewall or traffic filters.
If there is good IP connectivity, reset the shared keys (shared secrets) on the AP and the server to ensure they match.
Note: You may receive the No EAP-Authentication response for Station error message when trying to use Lightweight Extensible Authentication Protocol (LEAP) Proxy on any Cisco Secure ACS for Windows other than version 3.1.
Problem Type
Client / Device cannot authenticate
Error message
Products
Access point
Bridge
Security Options
EAP
LEAP / RADIUS
PEAP
Topology
Wireless client to AP
VxWorks Errors, Warnings, Statistics and Log Messages
No EAP-Authentication response for Station