Configuring a Lightweight Access Point through the Command Line Interface (CLI)

[Rajesh Premachandran]

This video explains how to configure a Lightweight Access Point through CLI. It also explains how the configuration commands behave depending on the version of firmware on the Wireless LAN controller.

[Vinay Sharma]

Thanks for sharing this useful information Rajesh.

Vinay Sharma

Community Manager- Wireless

[raviverma3187]

Nice Video

Somewhere I was checking the below command to configure the IP manually on LWAPP

config ap static-ip enable 145.240.146.45 255.255.255.128 145.240.146.1

[saabbas]

Dear Sir,

I'm using first time Cisco AP (AIR-CAP2602I-E-K9) pl. advice how to configure it step by step.

I'm trying by using console port(serial cable) using Putty and stuck on below-mentioned step

AP7426.ac1a.bef0#

pl. advice appreciates your prompt response.

Thanks & Regards