ANNOUNCEMENT - The community will be down for maintenace this Thursday August 13 from 12:00 AM PT to 02:00 AM PT. As a precaution save your work.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
181
Views
0
Helpful
1
Replies
Highlighted
Beginner

WLC -sending trap for network authentication failure

Hello community,

our customer has complained, that on SNMP trap message he is not able to see SSID to which client was trying to connect.

the message is for example :

Client 'X  (0.0.0.0)' which was associated with
interface '802.11a/n/ac' of AP X 1-A01' is excluded. The reason
code is '4(802.1X Authentication failed 3 times.)'.

 

could you help me out how to set up SNMP setting to see SSID/WLAN ? or it is not supported on WLC? 

 

 

1 REPLY 1
Highlighted
Cisco Employee

Re: WLC -sending trap for network authentication failure

Hello

 

For an authentication failure we do not see what is the SSID the client is trying to connect, we only see the SSID when the client has been successfully auth

 

Client Authenticated: MAC Address:d0:c0:bf:8d:a0:39, Base Radio MAC:2c:5a:0f:3b:d9:60, Slot:1, Username:Unknown, IP Addr:172.16.66.109, SSID:WPA3-Test

Content for Community-Ad