Hello, I have a Cisco 2921 router IOS 15.07 and I wanted to know if I could connect my Netgear Wireless router to it so that I could configure the Netgear as an Access Point? The Netgear wireless router has a section where it can be configured as an AP.Wo... view more

We have 2802's running 8.3.x code and a fleet of wireless comm badges that operate in 5ghz only. The vendor says to disable FRA which I did but I still see these things connecting to AP's that have the slot 0 radio in 5ghz mode. I would like for the XOR r... view more

Hello, I'm trying to make an AP join a controller over the internet, I think I've done all the setup needed to make this work, here's what I did so far : - booted the AP and defined the public IP address of the WLC in the WLC managers list( NAT ... view more

we have this AP  AIR 2802E working as ME(controller), its  firmware is 8.6.101.0 and backup firmware is 8.8.120.0 But a few AP (2802E) can be upgraded and is working, other APs(AIR2802) cannot be upgraded, so cannot join to ME (controller)&... view more

Hi,We have a WLC 5508 with 2 WLAN. One with 802.x WPA2 authentication and Second one with Web splash page authentication.We have a Radius server 2012 NPS. WAP2 802.x authentication work with Radius server.IssueSecond wlan  Web splash page authenticat... view more