Hi Everyone,
I am new to this board and I am having trouble seeing if my Wireless Distribution System is set up properly. I have gone into each WAP571 and added the other two WAP571's mac addresses to the 5GHz network. I can manually add the MAC address, but if I try to pick from the drop down list all WAP571's say they cannot see any other WAP571's. When I got to monitor - Dashboard - Wireless page I see nothing about WDS(X) I see eth0 and vlan1. All WAP571's have the latest firmware 1.1.0.3. I need to be able to allow inventory laptops to roam without interruptions between access points. The Procedures in Cisco manuals do not show the same thing on my screen, almost like different firmware pictures. I had them set up as separate access points, but the inventory laptops lose data when it disconnects from one and connects to the other. Any help would be appreciated. Thank you in advance. Look forward to some help. Thank You.
