WAP321 captive portal restriction on VLAN1

[klausts55]

I was reading through a couple of posts stating the captive portal feature on WAP321 is only supported on VLAN1 (admin VLAN); as in my installation, like in probably 99% of all, my guest VLAN where I need the captive portal for is NOT set to VLAN1 and will never be that. I'm wondering when Cisco will finally fix this issue and whether anybody has information on that. I could not find an entry in the release notes. thx

[Steve Hebert]

Captive Portal does work on other VLAN's.  You need to configure inter-vlan routing as appropriate and set up all aspects of CP including Web Portal Customization.

[Moin Ilyas]

Please refer to the following link, and check if that helps.

https://supportforums.cisco.com/discussion/11992766/wap321-captive-portal-2-different-vlan