WAP371 after upgrade to 1.3.0.6 fails

[jara]

I have 4 WAP371 in one "Single Point Setup" Cluster.

After "Cluster Firmware Upgrade" two of APs will not alive - I see APs have a connection to switch, power is up but did not respond on any IP.

In dump I see only packets

IP6 :: > ff02::1: HBH ICMP6, multicast listener querymax resp delay: 1000 addr: ::, length 24

IP 0.0.0.0 > 224.0.0.1: igmp query v2

every two minutes

What we can do for recovery of firmware?

[jara · Accepted solution]

we succeded with factory default (not only touching reset button but combination of reset button and power off/on) and we were able to reconfigure the AP with joining to cluster.

All is working now again