cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
167
Views
0
Helpful
3
Replies

1231G-E-K9 Converted to LAP not joining the WLC 2100 series

Sunish Nair
Beginner
Beginner

Hi,

I have converted one 1231G into LAP mode and while trying to register same into Cisco WLC, after loading with LAP image (Recovery Image) it giving below mentioned message and getting again its getting rebooted. Also i have noticed that its not taking any command were i can manually point to WLC. Auto reboot is happening within few seconds. Kindly proivde your experience related to similar issue. 

*Mar 1 00:00:05.360: %SYS-5-RESTART: System restarted --
Cisco IOS Software, C1200 Software (C1200-RCVK9W8-M), Version 12.3(7)JX9, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by Cisco Systems, Inc.
*Mar 1 00:00:06.315: %LINK-3-UPDOWN: Interface FastEthernet0, changed state to up
*Mar 1 00:00:07.315: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0, changed state to up
*Mar 1 00:00:24.381: %LWAPP-5-CHANGED: LWAPP changed state to DISCOVERY
*Mar 1 00:00:35.103: LWAPP_CLIENT_ERROR_DEBUG: spamHandleDiscoveryTimer : Found the discovery response from MASTER Mwar

*Mar 1 00:00:35.110: %LWAPP-5-CHANGED: LWAPP changed state to JOIN
*Mar 1 00:00:41.110: LWAPP_CLIENT_ERROR_DEBUG: spamHandleJoinTimer: Did not recieve the Join response

*Mar 1 00:00:41.110: LWAPP_CLIENT_ERROR_DEBUG: No more AP manager IP addresses remain.

*Mar 1 00:00:41.110: %SYS-5-RELOAD: Reload requested by LWAPP CLIENT. Reload Reason: DID NOT GET JOIN RESPONSE.
*Mar 1 00:00:41.110: %LWAPP-5-CHANGED: LWAPP changed state to DOWNXmodem file system is available.

3 Replies 3

Leo Laohoo
VIP Community Legend VIP Community Legend
VIP Community Legend

Kindly post the complete output to the following commands: 

1.  WLC:  sh sysinfo; 

2.  WLC:  sh time;  

3.  AP:  sh version; and

4.  AP:  sh ip interface brief

Txs for your reply...i need to request the output from other team it may take some time to get the output. Before that will you able to share what other thing i can try to fix this issue. 

Leo Laohoo
VIP Community Legend VIP Community Legend
VIP Community Legend

Before that will you able to share what other thing i can try to fix this issue. 

None.  Show me the complete output and it will determine why the AP won't join the controller.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers