1250 AP - 40mhz channel selection issue

[sjscott007]

Every time I try to enable the 40mhz channel bonding for the 5ghz radio I receive the following error message, "slot is not disabled or customize is not enabled". This occurs from both the web and CLI interface.

Thanks.

Steve

[Scott Fella · Accepted solution]

You need to set the power and the channel before you can enable the 40mhz channel width.

Use one of these for above 40mhz:

36,44,52,60,100,108,116,132,149,157

Use one of these for below 40mhz:

40,48,56,64,104,112,136,153,161

[Scott Fella]

Here is an okay link to look at:

http://www.cisco.com/en/US/solutions/collateral/ns340/ns394/ns348/ns767/white_paper_80211n_design_and_deployment_guidelines.html

[sjscott007]

That worked great. Thanks for your help!

Steve