09-28-2016 12:59 PM - edited 07-05-2021 05:54 AM
WLC 8500 with 8.0.120.0
I installed one 1572EAC-M AP on power injector.
When I check the power level allowed it's only 3 levels "16, 13, and 10"
The WLC "show country channels support tx-power" it allowes me to use 27dbm on certain channels, why can't I see those?
My country is SA
Thanks.
09-28-2016 10:16 PM
check your regulatory domain restrictions on both 2.4GHz and 5GHz bands.
If regulatory domain allows higher power level for the frequency band AP operate, then it could be a software issue of the 8.0.x code as well.
Refer this thread on similar issue but with different AP model
https://supportforums.cisco.com/discussion/12982941/low-tx-power-levels-cisco-3702i-ap
HTH
Rasika
*** Pls rate all useful responses ***
09-28-2016 11:29 PM
my WLC says
show country supported tx-power
27*27*27*27*27*27*27*27*27*27*27*16*16*16*16*
from channel 100 till 161 and my AP channel is 100 80Mhz
i have 3702 AP's and they are having the correct power level.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide