Wireless

Hi all, in regards to the 1140s, are there any guarantees that it will be fully N compliant once the protocol has been standardised?I know that the 1250s have a modular slot to ensure that it will be N compliant (once N has been standardised) as well...

Will the 1140 AP be supported on WLC Version 4.2?Or will it only be supported on Version 5.2?

Hi All,I am faceing the issue with Cisco Wireless. After switch reboot where APs connected APs comes with default AP Group. Also I am configured the static IP address, But after reboot the switch where APs connected they comes up with DHCP IP address...

hello, on the WLC 5520, is there a way to switch the image, i want my backup image becomes my primary... so in my Web Gui, i will see Primary :8.3.140, and backup 8.2.xxx , now, this is the opposit.   Tx B  

Hi All,   Is it possible to set 2.4 GHz band  coverage at a less than range 20Ft? 

Hello..really hope you can help as i am banging my head off a wall with this. I have setup a Cisco Aironet 700 series Access Point here in the office and am testing it (sitting next to the device) I am transferring from laptop (wireless) to server (w...

Our controllers are using NTP just fine. However, when looking at AP logs, the timezone, and possibly the date, are way off. It's probably using GMT for the timezone. I need to know how to get the APs to show the time and date we need, preferably by ...

I'm trying to use a Cisco ASA5510 to replace a 3750 router in a configuration with a WLC 4400.The solution works fine with the router but not with the ASA.Anyone knows if there is specific configuration to do on the ASA?Does the inspection engine dro...

 Hi All,   I've an 3802I AP's which is configured properly & working & now i'm decommissioning the AP. I've excuted below command from the controller  clear ap-config <ap-name>.   My question is will that AP will register back to the WLC? if below pa...