9115AXI AP is continuously blinking red, green and blue

[cjiwonder]

Recently, I connected a 9115AXI AP with a Cisco C1000 24P 4GL PoE switch, no other PoE devices are connected with this switch. AP joined with the controller and clients are connected without any issues but the AP is continuously blinking red, green and blue. I am sure that it's a PoE power issue. I have a few questions:

Does 9115AXT support the Cisco 24P 4GL 195W PoE switch?

As per my knowledge, each port supports up to 30W and it seems AP is consuming 15.4 watts only, Does 9115AXI require more power?

Thanks in advance.

[Leo Laohoo]

Console into the AP and reboot the AP. 

Post the entire bootup process.

[cjiwonder]

Attached.

[Leo Laohoo]

RMA the AP.

[marce1000]

  - This led pattern for sure indicates insufficient power provisioning ,

  M.