9800-40 initial setup

[syedimteyazahmad]

Hi All,

Need help for configuring 9800-40 standalone WLC. We have done bootup config for WLC. Also able to access through http. We defined dayzero config through GUI. Once we finish it , we got message configuration successfully applied then login page came. Once we put credential , it again ask dayzero config. 

Any specific reason for that

[Sandeep Choudhary]

I think you are not saving the config in NVRAM.

please follow the deployment guide:

https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/9800-40/installation-guide/b-wlc-ig-9800-40/power-up-and-initial-configuration.html

Regards

Dont forget to rate helpful posts