cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
629
Views
20
Helpful
9
Replies

9800 WLC - Central switching ( Not Flexconnect ) configuration

Wireless
Beginner
Beginner

Hi Cisco community. I want to verify what is the switchport configuration for the access points when using Central switching(Not Flexconnect mode) ? We are using 9800 wlc vm. thanks in advance

9 REPLIES 9

Scott Fella
Hall of Fame Guru Hall of Fame Guru
Hall of Fame Guru

switchport access vlan x is what you would use.

-Scott
*** Please rate helpful posts ***

Scott Fella
Hall of Fame Guru Hall of Fame Guru
Hall of Fame Guru

That is the preferred, but switchport trunk native vlan x would be the alternative.

-Scott
*** Please rate helpful posts ***

Hi, scott
switchport trunk native vlan x

sw trunk allowed vlan x, x, x,x  right?

That is an alternative you can use.  The preferred way is switchport access vlan X

Since you are using local mode, there is no reason to set the switchport to trunk.  Local mode just uses one vlan, which is the ap management vlan, so access port is preferred and simplifies the configuration.

-Scott
*** Please rate helpful posts ***