Activate remote access to the C9120AXI-A AP
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Informe de contenido inapropiado
el 07-16-2024 02:16 PM
Hi Community,
I have several APs connected to the WLC C9800.
I would like to know what the procedure would be to activate remote access of the AP C9120AXI-A?
In order to be able to enter each of the APs by cli.
And if I have a new AP C9120AXI-A, what would be its default password?
Waiting for your early reply.
Regars
Electronic20
- Etiquetas:
-
Wireless
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Informe de contenido inapropiado
el 07-16-2024 02:34 PM
Default credentials is Cisco/Cisco
"I would like to know what the procedure would be to activate remote access of the AP C9120AXI-A?"
If we are talking about a capwap AP which will be managed by your WLC, all you need to do is plug the AP in the network with WLC recheability and the AP is expected to join the WLC.
There is not much reason to connect to the AP using CLI <IF> the AP is managed by the WLC.
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Informe de contenido inapropiado
el 07-16-2024 03:09 PM
You can enable telnet/SSH access under the AP join profile. See the following documentation: https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9120axe-access-point/221056-understand-the-ap-join-process-with-the.html#toc-hId-1886668689
Get in touch: https://torbjorn.dev
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Informe de contenido inapropiado
el 07-16-2024 05:33 PM
Hi @Torbjørn
How can I factory reset the C9120AXI AP when I log in via cli? that is, by command lines