cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1129
Views
0
Helpful
3
Replies

Adjacent Channel interference

u297863AG
Level 1
Level 1

I read about 'adjacent channel interference'. Wanted to confirm with the experiened folks out there if there could really be a problem with 'adjacent channel' interference where the APs are on non overlapping channels but are placed too close together? If so, shouldnt RRM resolve?

3 Replies 3

Stephen Rodriguez
Cisco Employee
Cisco Employee

RRM will help, but it really can't 'fix' a bad design.  If you are too dense, the WLC may not be able to lower power enough to stop the interference.  

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

Saravanan Lakshmanan
Cisco Employee
Cisco Employee

with 5ghz, it should not be an issue.

with 2.4ghz, if ap power is least then it should not affect. when ap on max power, only side bands get affected due to overlap.

Are you able to 'see' this when looking at the channel from Cisco Spectrum Expert?

Review Cisco Networking for a $25 gift card