AP 1231 Configuration

[p.holley]

I always have this problem when I console to the AP1200 to start initial configuration. I see it boot up on the terminal, but when i press enter to get started, nothing comes up on th eterminal.

So I usually connect it to the network, allowing it to obtain a DHCP address and the access it with that IP address.

unfortunately this is not working now with a new AP I am setting up. It gets an IP address and I can ping it, but cannot telnet or web browse to that IP address to configure the AP.

Basically I cannot access the AP for configuration. Can someone help

[john.preves]

what happens if you reset it to default?

I would be interested in seeing what the vty 0-4 and vty 5-15 settings are but since you can't get in it...

[p.holley]

i have reset it to default several times by poering off the AP, holding down the button and then powering it back up and then releasing the mode button.

i am unable to access it via console and telnet so i dont know what the vty setting are

[virenderjaglan]

HI,

for reset the ap press mode button for 20 second then supply the power to the ap.

after that u can use console for access the ap via hyper terminal.

thanx