AP Statistics for C9800-40 Wireless Controller

[Bill]

We have a C9800-40 running version 17.9.3

I’m looking to see if there are AP Statistics like the old WLC 5508 had.
With the 5508 there were AP Usage and Throughput statistics.
I am not finding that with the 9800.

Are those statistics available on the 9800 ?

I we can enable AP Statistics, but that is for CPU and memory.
I’m not finding throughput statistics.

Thanks

[Mark Elsen]

 - Ref : https://www.cisco.com/c/en/us/td/docs/cloud-systems-management/network-automation-and-management/dna-center/2-2-3/release_notes/b_cisco_dna_center_rn_2_2_3.html
                      Looks like DNA center may provide this 
>...

AP - Usage and Client Breakdown

This release supports a new AP - Usage and Client Breakdown report. This report provides analytics data about total usage through selected access points and breakdown of the clients and traffic by OS types, SSID, and VLAN. Supported report file formats include PDF, CSV, TDE, and JSON......

 M.

[Bill]

Thanks for the Reply.
I noticed that too,
Unfortunately, we do not have DNAC.

[Leo Laohoo]

sh ap summary load-info

[dmetheny]

You can see AP statistics by going to Monitoring > Wireless > AP Statistics, then selecting the AP you want to view statistics for towards the bottom of the pop-up window.  It isn't formatted the same as the 5508, but it provides some decent radio utilization data.

Hope this helps!

[Ambuj M]

lot of good suggestions, would also recommend these set of command on 9800 for monitoring key KPIs for APs.

https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/217738-monitor-catalyst-9800-kpis-key-performa.html#anc4