cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
429
Views
0
Helpful
0
Replies

APs Controlled from Agent instead of WLC?

I have 8 APs directly connected to a stack of 3850 switches operating as the WLC. I have 4 more APs connected to another 3850 stack on a different floor operating as a wireless mobility agent. I have a trunk link directly between the two 3850 stacks. If I log into the GUI for each of the stacks, I can see the APs that are connected to each stack, respectively. I have no visibility from the WLC to the APs that are connected to the agent.

Is this the normal behavior? Do I have to do my management of AP groups and WLANs at both the WLC and the agent? Was I mistaken in my understanding that the WLC operates as a central point of control? Below is the wireless mobility summary output from each stack:

WLC Stack:

Mobility Controller Summary:

Mobility Role                                  : Mobility Controller

Mobility Protocol Port                          : 16666

Mobility Group Name                            : default

Mobility Oracle IP Address                      : 0.0.0.0

DTLS Mode                                      : Enabled

Mobility Domain ID for 802.11r                  : 0xac34

Mobility Keepalive Interval                    : 10

Mobility Keepalive Count                        : 3

Mobility Control Message DSCP Value            : 60

Mobility Domain Member Count                    : 1

Link Status is Control Link Status : Data Link Status

Controllers configured in the Mobility Domain:

IP              Public IP        Group Name      Multicast IP    Link Status

-------------------------------------------------------------------------------

10.10.60.3      -                default          0.0.0.0          UP  : UP

Switch Peer Group Name            : SPG1

Switch Peer Group Member Count    : 1

Bridge Domain ID                  : 60

Multicast IP Address              : 0.0.0.0

IP              Public IP            Link Status

--------------------------------------------------

10.10.60.2      10.10.60.2            UP  : UP

Agent Stack:

Mobility Agent Summary:

Mobility Role                                  : Mobility Agent
Mobility Protocol Port                          : 16666
Mobility Switch Peer Group Name                : SPG1
Multicast IP Address                            : 0.0.0.0
DTLS Mode                                      : Enabled
Mobility Domain ID for 802.11r                  : 0xac34
Mobility Keepalive Interval                    : 10
Mobility Keepalive Count                        : 3
Mobility Control Message DSCP Value            : 60
Switch Peer Group Members Configured            : 1

Link Status is Control Link Status : Data Link Status

The status of Mobility Controller:

IP              Public IP            Link Status
------------------------------------------------
10.10.60.3      10.10.60.3          UP  : UP

Switch Peer Group members:

IP              Public IP            Data Link Status
-----------------------------------------------------
10.10.60.2      10.10.60.2          UP

0 Replies 0
Review Cisco Networking for a $25 gift card