Wireless

HI can someone help me please? I'm trying to have AP grouping on my network under the same SSID. the problem I'm having is the client are fine if they boot up initially on their location. they are fine if they roam around and maintain the connectivit...

  Hello , kindly as far as i understand that option 82 is to add identifier like AP-MAC into DHCP requests ,  however , if you have a large scale deployment for thousands of access point  , so is it practically  to configure in the DHCP server a list...

Hi I am using Cisco secure ACS version 5.5.4 , I have done required configuration to implement tacacs+ for router and switches Now I am able to login on router and switches and i have synchronized my authentication with AD Issue is that when i used t...

I have a Cisco Aironet access point AIR-CAP3602I-A-K9. I connected it to my laptop (running Windows 8.1 Pro 64 bit) with a USB-to-DB9 and DB9-to-RJ45 console cable. I could not open CLI via Putty or SecureCRT. After waiting several minutes, I only go...

I have a Cisco Aironet access point AIR-CAP3602I-A-K9. I connected it to my laptop (running Windows 8.1 Pro 64 bit) with a USB-to-DB9 and DB9-to-RJ45 console cable. I could not open CLI via Putty or SecureCRT. After waiting several minutes, I only go...

I have a WLAN SSID that currently does not have flexconnect enabled.  I am preparing to deploy some APs at a remote site and will use local switching there to save WAN bandwidth.  If I enable flexconnect on the WLAN and not the APs, will clients curr...

HiI have a WLC 5508 and 4408 servicing 100 APs. the problem is client wont connect to the closest AP! this problem leads to creating over association situation for one AP. I have tried disabling the slow data rate. I tried the Client Load Balancing  ...

Hi,We are starting to see requirements for the new 802.11ac AP's to be deployed for Voice/Video applications (Lync, Jabber) and I want to know the "rule of thumb" for calculating the number of devices per AP (2700/3700 models).In the past 802.11b/g/n...

Hi, I have two WLC 8500 working in SSO and with nat enable feature configure in management interface. SSO is working, but i have to configure NAT before SSO becasuse when SSO is up, ip address and nat are greyed out in managemente interface. Some AP'...

hello,was hoping someone might be able to assist with the following:  i am trying to configure local LAN ports on my 702w AP's for access mode and vlan from AIR-5760 CLI.  can find good examples of how to do this in Air-OS, but not in IOS-XE.  i mana...

Hi Cisco,I need to change the SSID name in Flexconnect mode. However it seems not possible to parallel run the old and new SSID in single VLAN. What is the recommendation to have the both SSID with same IP range, Auth server, so that we will have tim...

Hi,I would like to schedule the enable or disable of a specific WLAN only in a specific AP-Group.Is possible to do with a Prime?Regards.Mirko Severi. 

Able to get voice working on the 702W but now would like to use port 1 as a data port.   I have been no been able to connect via data.   the AP702 is connected via 2960S access port.  If you have been able to get the data port working on the AP702 ca...