Hello, i have few questions on wireless work group brid:
1. %DOT11-4-CANT_ASSOC: Interface Dot11Radio0, cannot associate: assoociate response status (18) unsupported data rates
what does the error indicate on a 1310 acting as work group bridge
2. we can see the dot11radio 0 inteface in reset status on the bridge
Interface IP-Address OK? Method Status Protocol
BVI1 192.168.121.5 YES NVRAM up up
Dot11Radio0 unassigned YES NVRAM reset down
FastEthernet0 unassigned YES NVRAM up up
what could cause it and how to correct it
3. on 5500 wireless lan controller, we see some of the work group bridges in excluded mode after initially seen normally.
what causes this & best way to correct it
4. when we check the dot11 associations on the bridge, it indicates some activity timeouts.
do we need to set them manually and what is their purpose
