Cisco 1602 E standalone AP not connecting to RAP AP!

[Cap-24]

I am having trouble with one standalone access point (Cisco 1602E) not connecting to a Lightweight Access Point (Cisco 1552)AP. I am unsure if this is a hardware issue or not. I tried restoring to factory settings, but did not work. I have these AP’s connecting fine. I have attached the log, which lists some of the issues. 

I am using a WLC 5500 to manage this set up.  Thanks in advance for any help on this topic. 

[Cap-24 · Accepted solution]

I resolved this issue via a factory reset and the copying a config file from another one of these access points that connected properly.