Is there a way to configure cisco WLC to automatically set flexconnect parameters such as Vlan support and Native Vlan ID when an access point join the controller ?
Same question to assign the access point to a specific AP Group ?
PS: The access points are set with usine parameters and the WLC is in version 7.4
Thank you for your answers !
To my knowledge these features are not available in 7.4, but from what I understand 8.0 will have similar features. I can say that 7.6 has global commands, not sure if its part of 7.4.
If it is you can navigate there Wireless>Access Points>Global Configuration you can do things like configure your primary and backup controllers, set login credentials, pre-download images to AP's.
Please rate if you find the information helpful.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: