09-24-2013 03:57 AM - edited 07-04-2021 12:55 AM
Dear All,
I have extened my coporate office wireless network to my branch locations using H-REAP. While connecting to this wireless netwrok from the branch locations I am getting the IP address from corporate office DHCP server. Is it possible to get IP addresses from the local DHCP servers at the branches ?
WLC - 5508
AP - 1242
Regards,
Shijo.
Solved! Go to Solution.
09-24-2013 04:59 AM
You need to look at this guide. You need to assign the WLAN the vlan mapping and make sure the AP is connected to a trunk port. Also on the WLAN, you need to enable local switching.
https://supportforums.cisco.com/docs/DOC-24082
Sent from Cisco Technical Support iPhone App
09-24-2013 04:59 AM
You need to look at this guide. You need to assign the WLAN the vlan mapping and make sure the AP is connected to a trunk port. Also on the WLAN, you need to enable local switching.
https://supportforums.cisco.com/docs/DOC-24082
Sent from Cisco Technical Support iPhone App
09-24-2013 01:02 PM
If it is already configured for H-REAP local switching with correct vlan mapping, you have to make sure you configure correct "ip helper-address x.x.x.x" to pointing to branch DHCP server under SVI defined for wirless users at branch.
If DHCP server is the same switch where you defined the SVI then it is not mandatory.
HTH
Rasika
10-01-2013 02:03 AM
Hi Scott,
Thank you very much. Its working now.
Regards,
Shijo.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide