11-09-2012 01:41 PM - edited 07-03-2021 11:00 PM
Hi,
Do we have enable mod eon 2112 WLC ?
Also if we need to access WAP from WLC how can we telnet or ssh?
Thanks
MAhesh
Solved! Go to Solution.
11-09-2012 02:27 PM
Do we have enable mod eon 2112 WLC ?
No.
Also if we need to access WAP from WLC how can we telnet or ssh?
First you need to join the AP to WLC, WLC>>wireless>>AP click on the AP and select Advanced tab, there you can see telnet, ssh check box.
11-10-2012 10:07 PM
There is no enable/config modes in WLC because it does not run IOS.
You need to enable either SSH or telnet (or both) on the AP from the controller settings (Saravanan metnioned the exact location where to do that in his previous reply. Thanks Saravanan). After enabling that you can telnet or ssh as you want from whatever terminal that can reach the AP on the network. (default username and password for telnet/ssh is Cisco/Cisco. You can change that from the AP settings as well on the WLC).
HTH
Amjad
Rating useful replies is more useful than saying "Thank you"
11-09-2012 02:27 PM
Do we have enable mod eon 2112 WLC ?
No.
Also if we need to access WAP from WLC how can we telnet or ssh?
First you need to join the AP to WLC, WLC>>wireless>>AP click on the AP and select Advanced tab, there you can see telnet, ssh check box.
11-10-2012 10:07 PM
There is no enable/config modes in WLC because it does not run IOS.
You need to enable either SSH or telnet (or both) on the AP from the controller settings (Saravanan metnioned the exact location where to do that in his previous reply. Thanks Saravanan). After enabling that you can telnet or ssh as you want from whatever terminal that can reach the AP on the network. (default username and password for telnet/ssh is Cisco/Cisco. You can change that from the AP settings as well on the WLC).
HTH
Amjad
Rating useful replies is more useful than saying "Thank you"
11-14-2012 11:12 AM
Hi Saravanan and Amjad,
Many thanks for your replies.
sorry for late rating of post.
Regards
Mahesh
04-21-2013 11:00 AM
Hello Mahesh
Thanks for Rating.
Thanks
Saravanan
04-21-2013 02:38 AM
Do we have enable mod eon 2112 WLC ?
No.
You need to enable either SSH or telnet (or both) on the AP from the controller settings (Saravanan metnioned the exact location where to do that in his previous reply. Thanks Saravanan). After enabling that you can telnet or ssh as you want from whatever terminal that can reach the AP on the network. (default username and password for telnet/ssh is Cisco/Cisco. You can change that from the AP settings as well on the WLC).
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide