
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-14-2021 08:08 AM
I have gone through the documentation on setting up Guest wireless. We want to have the user enter a username and password.
We are using Aironet 2802I access points with Mobility Express - version 8.10.151.0
I have configured the guest network.
Under WLAN Security I have the following
Guest Network - enabled
Captive Portal Assistant - enabled
MAC Filtering - disabled
Random MAC Filter - disabled
Captive Portal - Internal Splash Page
Access Type - Local User Account
ACL Name(IPv4) - Guest
ACL Name(IPv6) - None
Under VLAN & Firewall I have
Client IP Management - Mobility Express Controller
Peer to Peer Block - disabled
Native VLAN - 30
Use VLAN tagging - option disabled
DHCP Scope - SSMIC-GUEST
VLAN ID - 37
Enable Firewall - no
VLAN Name VLAN ID
MGMT 30
Guest 37
SSMIC 29
WLAN Users
User Name - ssmic guest
Guest User - yes
Lifetime - 86400
WLAN Profile - SSMIC-GUEST
Guest WLAN
Page Type - Internal (Default)
Display Cisco Logo - Yes(Default)
Redirect URL after login - www.ssmic.com
Page Headline - SSMIC
Page message - Sault Ste Marie Innovation Centre
When I click the preview button it shows the correct page.
When I try to login to the guest network I get a completely different page.
https://192.0.2.1/login.html?redirect=www.gstatic.com/generate_204
On the page it says Connect to Wi-Fi
The wi-fi you are using (SSMIC-GUEST) may require you to visit its login page.
There is a connect button on the page but it doesn't do anything.
This page pops up automatically when I connect. The laptop gets an IP address from the set scope and when I check clients in the controller it shows the laptop is connected.
What am I missing? Why am I not getting the page that shows when I click on preview in the controller.
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-14-2021 10:30 AM
In best practices settings did you disable HTTP? I had a similar issue where I enabled HTTPS for management and it would no longer let the device redirect to the login page. under the webauth global setting, I had to run the command webauth-http-enable.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-14-2021 10:30 AM
In best practices settings did you disable HTTP? I had a similar issue where I enabled HTTPS for management and it would no longer let the device redirect to the login page. under the webauth global setting, I had to run the command webauth-http-enable.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-14-2021 12:17 PM
So thanks for the reply. Although, I don't seem to have the command webauth-http-enable, I did change the setting in the gui
HTTP Access - changed to enabled
and that seems to have worked.
Thanks again
Gord.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-14-2021 01:33 PM
I believe you have to create a parameter-map type webauth global, then ad the webauth-http-enable.
