07-01-2020 09:38 AM - edited 07-05-2021 12:14 PM
Hello All,
i have a cisco air-ap 1852i -E-K9 and i cant go to web interface , and in console interface i stack in (cisco controller) >
some one help me pls
thank you
07-01-2020 05:59 PM
07-02-2020 01:54 AM
Hello Scott Fella,
yes i have read all configuration guides but i can't understand the probleme , for infomation i have 8.10.122.0 image , normaly this cisco ap 1852i show a SSID Ciscoairprovision but i cant find that, am gonna join a picture explain when i stack
thank you alote for your answer
07-02-2020 06:30 PM
07-03-2020 02:39 AM
Hello Scott Fella
so how can i configure the ap using CLI : pls can you send me commands or tutoriel expalin how to get http/https?
Thank you alot
07-03-2020 03:22 AM - edited 07-03-2020 03:23 AM
Configure the management interface properly on it and then configure the switchport as well.
How to configure mgmt interface:
config interface address management <ip-addr> <ip-netmask> <gateway>
config interface quarantine vlan management 0
Switchport where AP is connected: (Example)
interface GigabitEthernet1/0/37
description » Connected to AP «
switchport trunk native vlan 122
switchport trunk allowed vlan 10,20,122
switchport mode trunk
Regards
Dont forget to rate helpful posts
07-03-2020 04:20 AM
hello Sandeep Choudhary
i cant put this commands in CLI( console), whene i turn on my cisco 1852i go directly to conlroller config ( Cisco controller > ). for infomation i dont have a controller , so i need just to turn my cisco 1852i to a normal Access point can i do this ?
Thank you a lot
07-03-2020 05:16 AM
Hi,
Try to go in AP Console
Controller> ap (Type ap and press tab) and check
Rgds/Sudhir
07-06-2020 02:31 AM
07-03-2020 05:57 AM - edited 07-03-2020 05:58 AM
It will only work as Mobility express AP/WLC.
Check the guide to deploy Mobility express:
https://www.packet6.com/deploying-cisco-mobility-express/
https://www.lookingpoint.com/blog/mobility-express
Regards
Dont forget to rate helpful posts
07-03-2020 06:58 AM
07-06-2020 02:38 AM
Hello Scott Fella,
yes exactly i watch alot of videos and blogs, but all most videos and blogs use SSID method, i keep searshing
Thank you alot
07-06-2020 02:35 AM
Hello Sandeep Choudhary
this URLs tell to install cisco with SSID "Ciscoairprovision" but in my cisco SSID not showing,
thank you for the answer
07-06-2020 05:11 AM
check the swicthport config where AP is connected.
It must be configured in this way:
interface GigabitEthernet1/0/1
description **Master ME AP**
switchport trunk native vlan 10
switchport trunk allowed vlan 10,20,30
switchport mode trunk
Regards
Dont forget to rate helpful posts
07-06-2020 07:25 AM
Hellloo ,
Thank you so much sandeep Choudhary, now i can run myc cisco 1852i like AP
thank you alot
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: