How to configure WPA2 on Cisco AP 1220?

Javier Alberto Rivera Chavez · ‎11-14-2013

Good day,

I wonder if my CISCO AP 1220 with IOS Version 12.2 (8) JA, can be configured with WPA2. What should I do to make it?

thanks

Scott Fella · ‎11-14-2013

That code doesn't support WPAv2 and I believe the hardware itself also doesn't support WPAv2.

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***

Javier Alberto Rivera Chavez · ‎11-14-2013

Are you sure?? in the datasheet says it supports:

Sandeep Choudhary · ‎11-14-2013

Hi Javier,

WPA is not supported on your IOS Version 12.2 (8) JA.

You must upgrade the IOS image to atleast 12.2(11)JA to support WPA feature.

After updation u can configure wpa like this:

ap1200# configure terminal

ap1200(config)# interface dot11radio 0

ap1200(config-if)# encryption mode cipher tkip

ap1200(config-if)# ssid xyz

ap1200(config-ssid)# authentication open

ap1200(config-ssid)# authentication key-management wpa

Hope it helps.

Reagrds

Javier Alberto Rivera Chavez · ‎11-14-2013

Hi,

I need configure WPA2. I know WPA is supported to cisco AP 1220.
thanks

Sandeep Choudhary · ‎11-14-2013

Hi Javier,

if you need to configure wpa2 on 1220AP.

Then u must have

• Cisco IOS Software Release 12.3(8)JA or later (autonomous).

• Cisco IOS Software Release 12.3(11)JX or later (Lightweight Mode).

AP> enable

AP# configure terminal

AP (config)# interface dot11radio 0

AP(config-if)# ssid Admin

AP (config-if-ssid)# vlan 30

AP(config-if-ssid)# authentication open

AP(config-if-ssid)# authentication key-management wpa version 2

AP(config-if-ssid)# wpa-psk ascii your-key-here

Hope it helps.

Regards

Please rate helpful posts and marked as answered if u are satified with answer.

kaaftab · ‎11-14-2013

kindly check the following link for configuration