How to modify RADIUS Servers on a 4402 controller?

[John Macko]

I have several controllers, including a 4402 running 6.0.188.0 software and I need to modify the Radius servers that it uses. Currently I have three servers listed;

1 - 10.246.194.16

2 - 10.200.31.78

3 - 10.247.50.56

I would like to delete server 1 which is being retired and replace it with a new server 1. I suspect, once i get servwe 1 deleted, the server 1 option would become available when I create a new server. I went into the controller and disabled server one, but every time I try and delete it, I get the "Server in use either on a specific WLAN or Mesh Radius Server Configuration" error. I can't find anywhere this server is still in service and being used, either by a WLAN or a Mesh. I've tried several different variances to modify this and have run out of ideas. What I hope to avoid is the need to reset the controller. I have a total of seven controllers that I need to make this modification to, and It will be ugly if I have to reboot these units. Hospital mission critical stuff.

Regards,

[Vinay Sharma]

Hi,

Are you still facing this issue?

thanks,

Vinay

[pt]

I am,

AIR-CT5508-K9

Product Version.................................. 7.0.230.0

Bootloader Version............................... 1.0.16

Field Recovery Image Version..................... 7.0.112.21

Turned off all WLANs

Deleted WLAN which used Radius

Nothing,  now doing a recover-config and trying to start over

[Saravanan Lakshmanan]

did you try from cli.

you could disable the decomissioned rad server

are you able to delete other rad server, and or add/create new radius server then you are good for now

WLC>show switch config

May be the config is corrupt on wlc.

backup the config, delete the required radius server, restore the edited config, reboot the WLC, sorry

[pt]

I had tried disabling all WLANs, deleting the WLAN which used the servers, neither helped.

Tried the same from the command line, which also did not help.

I was not able to change the shared secret for the Radius servers either, which was originally all I had wanted to do.

Fortunately most of my controllers are cookie cutter from one another and I was able to recover-config and copy the configuration of a WLC from a different hospital and change the relevant interfaces and all was well.

[Parmanand Patil]

I am also facing the same problem, I did not get the solution from above post.

Can anyone help me as I am trying to configure the WLC to add into radius for MGT user authentication & its not working.

At the same time my network user's are being authenticated from radius server's configured in WLC.

Regards,

PSP