Solved: How to use the Cisco AP 2700 series GUI

suleman.rahman05 · ‎02-01-2021

How can I access the Cisco Aeronet AP 2702i device via a web browser (GUI) in detail, the IP address has been detected but cannot be accessed via the website, here is the attachment

Scott Fella · ‎02-01-2021

Take a look at the configuration guide. With majority of Cisco devices, you would need to have a console cable to get the basic settings configured before you can http/https to the device. Here is a link that can help you get started:

https://community.cisco.com/t5/wireless-mobility-documents/autonomous-ap-and-bridge-basic-configuration-template/ta-p/3112198

-Scott
*** Please rate helpful posts ***

View solution in original post

marce1000 · ‎02-01-2021

- Using the CLI use : ip http secure-server

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

suleman.rahman05 · ‎02-01-2021

Can you give a detailed description, I don't understand

Scott Fella · ‎02-01-2021

Take a look at the configuration guide. With majority of Cisco devices, you would need to have a console cable to get the basic settings configured before you can http/https to the device. Here is a link that can help you get started:

https://community.cisco.com/t5/wireless-mobility-documents/autonomous-ap-and-bridge-basic-configuration-template/ta-p/3112198

-Scott
*** Please rate helpful posts ***

suleman.rahman05 · ‎02-01-2021

thanks -Scott-

Roman_1978 · ‎12-19-2021

Hi Scott

I have the same problem, the only difference is that I entered in CLI all the necessary commands to activate the GUI (ip http server; ip http secure-server; ip http authentication local), but I can't enter to the GUI. I tried many passwords and user ID. Did the factory reset several times. I can open the GUI on my web brouser but cant enter to GUI. May be you can advise me something.