Movinn a LAP from a WLC to another WLC

[marcellosozzo]

Is it possible to move a LAP associated to a WLC to another WLC?

Can i do it from WLC or WCS?

thanx

marcello

[ericgarnel]

You can do it from either. change the primary controller setting under the AP properties to point to the new controller and then save and reset the AP

[marcellosozzo]

I have done as you suggested, specifing only as primary the desired WLC.

The LAP, which was configured by priming procedure, indeed still joints to same WLC, though its ip address was inserted in the controller list.

WLC software version is 5.0.148.0

best regards

marcello

[ericgarnel]

Have you tried reseting it back to defaults?

[marcellosozzo]

Yes, the reset has be done in all the possible ways.

marcello

[ddmoe]

Does the AP have a self signed certificate? If yes, make sure it is on both WLC's.

[Scott Fella]

Place the ap on the same subnet as the WLC you want it to join and set the WLC as the master. the ap will need an IP on the subnet and should be able to join this way. If this ap has a SSC, you will need to add that into the WLC.

[ericgarnel]

Verify that the 1st WLC is not setup as a "master" controller too

[Saurav Lodh]

https://supportforums.cisco.com/thread/2025341 , please follow