Re: MR57

ahmed01baryoul · ‎10-12-2023

hello community

i'm facing a problem through the configuration of SSID of the MR 57

i create an account meraki then i create a network and attach the device to it
mooving on , i configure an SSID for the MR57 but the ssid does not appear in the wifi list but an SSID named "Meraki setup" appears
what is the problem ?

Karsten Iwen · ‎10-12-2023

If you see this SSID, likely, the AP could not register with the cloud.

I would first reset the AP if it was used before somewhere else and make sure that it is connected to a port where a valid IP config is provided by DHCP.

Then make sure the AP comes online in the dashboard. After that you should see your configured SSID.

--
If you found this post helpful, please give it Kudos. If my answer solves your problem, please click Accept as Solution so others can benefit from it.

ahmed01baryoul · ‎10-12-2023

thanks
should i delete it from the Meraki dashboard ?
then after reset it i add it ?

Karsten Iwen · ‎10-12-2023

You can leave it ion the dashboard network for the reset. It should come online shortly after.

--
If you found this post helpful, please give it Kudos. If my answer solves your problem, please click Accept as Solution so others can benefit from it.

aleabrahao · ‎10-12-2023

A very relevant question here is, does the ap appear as online on the dashboard?

I am not a Cisco employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

ahmed01baryoul · ‎10-12-2023

thanks
the problem is resolved